Can the Shapeoko Engrave On Stainless?

Big shout out to Mike over at The Backyard Machine Shop

y'all go check his channel out



I didn't know how the Shapeoko was going to do engraving on the stainless but it and the vbit I was using held up pretty well.

Cutting the pocket into the mdf wasteboard and using that to locate worked better than expected, the parts never came up and repeatability wasn't an issue either.

The v-cutter I ordered from ToolsToday wasn't made for stainless but it worked pretty well.

There must have been a small flat because the letters were a little fatter than I had intended but it still looks good.

CyberLink,PowerDirector18,cnc,shapeoko,diy,machinist,toolstoday,carbide3d,